/ crusher fingerboard mount - how do I attach a beastmaker?
Any advice would be appreciated.
Just screw it on James, through the pre drilled holes. Make sure the screws go all the way into the ply and that should be fine.
Is it better to drill some right through?
If you want it to stay looking that way then just draw the outline of the beastmaker on the ply, mark some points where there will be no holds on the beastmaker then screw from the back.
Also, there are holes in the back of the beastmaker which just go into the wood and not right through. JSA, is this the kind of method that you mean? Through the mount into holes on the fingerboard like this?
And without sounding totally stupid... The holes are 4mm in diameter, do I just need a 4mm screw? I'm guessing that's how it works haha!
Screw through the BM into the mounting board. Use screws slightly larger than the holes. ie #6 or #8 screws. Sorted.
What Fraser said.
You should be crushing when you come over.
Hopefully get some good routes ticked Andy, psych levels are high!
Elsewhere on the site
A recent e-petition calls for wild camping to be officially legalised on open land and National Parks in England and... Read more
F ounded in 1993, Mountain Hardwear are a pretty young mountaineering clothing and equipment manufacturer but are also one of... Read more
Winner of Best Adrenaline Film at the 2014 Kendal Mountain Fild Festival **** 'An outstanding collection of films... Read more
Ramblers Scotland are inviting walkers to contribute to a new 10-year 'vision' for walking, which will set out what the charity... Read more
Rock shoes stink – let’s face it. Boot Bananas are the perfect way to fight the funk and keep them fresh. They help... Read more